I'll preface this by saying that I don't have a lot of experience with ski jigs, but I do have a whole lot of experience with high end manufacturing and the quality of this tool is easily on par with many of the best that I've used over the years.
It is very nice to use after several hand mounts using paper templates. Even on the first go-round, it's waaaaaay faster and more precise. Just set it and go. It would almost be a full 5-stars, if not for a few nitpicks...
-For whatever reason, the jig has a tendency to ride up above the topsheet as it's tightened down. Not a showstopper, but something to be aware of as you're getting ready to go. There are certain dimensional tricks that makers of high-end vises use to prevent things like this from happening. Could probably be implemented fairly easily in future iterations of the tool.
-It would be very convenient if the 'deck' of the tool extended out further towards the side of the jig so that it'd be easier to set the drill bit depth before taking the plunge. I use a stop on the drill bit (with some visual cues to make sure it hasn't slipped during the process), and having the top surface of the jig extend to the edge would help with setting depth. There is one very small radius on the front end that allows this, but it's a little finicky.
-The last critique is probably my biggest. The toe pieces at the front and 'post' for setting the tech gap at the rear seem to have been assembled with a loctite formula that is entirely inappropriate to the bolt size. I got the toe pieces off, but the post will take come heating to break free. I would wager that the ATK folks just don't want anyone to remove these in the first place. But, in my case, it's causes two issues by not being able to remove these. The first is that my drill and drill bit combo will bottom out on the post (I was mounting Trofeo's, so the tightest spacing at the back). Not the end of the world, but I don't like having so little grip on the bit when I have to run it out of the drill further. Had the bit slip multiple times. The other issue is that if you have to use a tap (I'm using quiver killers), then you can't use a regular tap handle to thread the holes. It prompted me to finally get a ratcheting tap handle, but it was annoying in the moment. All that to say, I understand that they are likely meant to be mounted 'permanently', but I'll almost certainly be breaking that rear bolt free so I can remove it at the appropriate time during the next mount. I also think it'd probably be helpful to be able to reverse the rear post for bindings that use a 'kiss' gap rather than the traditional standoff. Though not sure if any of those bindings actually use the bolt patterns that this tool has...
I don't want my few quibbles to make it seem like this isn't a terrific tool. It really is, and makes me 1000% more confident in my mounts. There are just a few improvements that'd put it over the top and make it a truly flawless tool.